Electronic Circuit Board Cleaner Spray

Yes, if the cleaner is designed for circuit boards and used according to the product label and SDS. ZL98 High Purity Plastic Safe Contact Cleaner is non-conductive, non-flammable, rapidly evaporating, residue-free, and tested safe on many plastics and rubbers used in electronic assemblies.

Hold the aerosol can upright and spray according to the product label, targeting areas with oil, grease, condensation, dust, or particulate matter. Allow the cleaner to fully evaporate before returning equipment to service. For heavily soiled boards, repeat application may be needed. Follow SDS guidance and facility safety procedures.

ZL98 High Purity Plastic Safe Contact Cleaner is dielectric to 18,000 volts. Z99 Safety Solvent Degreaser is dielectric to 36,000 volts under ASTM D-877. Both products are non-conductive, non-flammable, self-evaporating, and designed for electrical maintenance applications when used according to the product label, SDS, and facility safety procedures.

Yes. ZL98 is tested safe on neoprene, Buna, silicone, butyl rubber, natural rubber, nylon, Hypalon, PTFE, PVC, polyurethane, polystyrene, polyethylene, polypropylene, epoxy, ABS, and most plastics, paints, and rubbers. For Z99, follow the product label and test sensitive materials when needed.

No. ZL98 and Z99 are self-evaporating formulas designed to leave no residue after application. This is important for sensitive electronics, contacts, relays, circuit boards, and electrical equipment where residue could affect performance or attract new contamination. Allow the product to fully evaporate before returning equipment to service.

Yes. The Z99 Safety Solvent Degreaser is available in both aerosol (12 x 20 oz cans per case) and bulk formats including 5-gallon pails and 55-gallon drums, with volume pricing available. The ZL98 is available as 12 x 16 oz aerosol cans per case. Contact Zircon at 800-547-4328 for bulk pricing.